Offshoreonly.com - nose cone epoxy

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - nose cone epoxy (https://www.offshoreonly.com/forums/general-q/250810-nose-cone-epoxy.html)

ThisIsLivin

06-14-2011 01:58 PM

Make sure you block sand the epoxy, it's harder than the cast aluminum. I used the epoxy to fill in the nose cone to lower unit, I had to use a belt sander to get it close, it was like sanding steel.

picklenjim

06-14-2011 02:36 PM

Quote:

Originally Posted by rssteiny (Post 3428931)

How well does the low water pick up slots line up do you need to do some modifing on that as well and where do i get the epoxy.

Also about how long does it take per drive to do this.

Some nose cones come with the epoxy. I know hydromotives do. Should be able to do them both in a 2-3 days with drying-sanding-painting.

rssteiny

06-20-2011 01:48 PM

My drive have slots in them for low water pick up how does the nose cones work with that do i need to cut slots to match or what.

wjb21ndtown

06-20-2011 03:55 PM

Quote:

Originally Posted by blue thunder (Post 3429001)

Here's where I got mine to reinstall my bobs nosecone. Works great and packaged as enough for one nosecone. It was around $25.

http://bobsmachine.com/

That website sucks

How thick can you put on the Sea Goin Poxy Putty? And how well does it apply/smooth out with a typical applicator?

All times are GMT -5. The time now is 11:42 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page