330hp 454 dies at idle.
#12
Charter Member #232
Charter Member
Thread Starter
Richard, if the coil was bad wouldn't it get worse at higher RPM's. or show up as a skip at all RPM's?
__________________
Put your best foot forward!
Put your best foot forward!
#13
Gold Member
Gold Member
Join Date: Jun 2009
Location: Williamsburg, MI
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
I have an 18 Donzi with a 330hp 454 in it. The boat has always had a very small mid range bog but I never looked into it and assumed it was carb. It did not bother me enough to look into why. Last year all of the sudden after the boat warmed up it would die at idle. I rebuilt the card and it still did the same thing, replaced points the other day still the same thing. Anyone have any ideas. It starts up good, seems to run smooth for about 15 min then it will start surge almost like a blower roll, slowly at first then more and more tell it dies. I have not done plugs since I purchased the boat because I don't put a ton of hours on it. Maybe the stuff I use to winterize fouled up a plug? I have not tested to see what it is pulling for vacume. I am going to try and get a friend to help me out this weekend if he can.
#14
Charter Member #232
Charter Member
Thread Starter
No it was not soaked we just sprayed cleaner and then used compressed air to clean them out. Idle Mixture screwes I have messed with. When you get it running OK warm then it is a mess cold and vice versa. I am really starting to lean towards the carb needing to be rebuilt again.
Jon
Jon
__________________
Put your best foot forward!
Put your best foot forward!
#16
Charter Member #232
Charter Member
Thread Starter
330's have run for ever on the Q jets. They are nice and efficient as well. Wouldn't I have a lot more fuel burn with a Holley and also have to swap over the intake?
__________________
Put your best foot forward!
Put your best foot forward!
#17
Registered
Join Date: Jan 2009
Location: Wilson, NY
Posts: 935
Likes: 0
Received 0 Likes
on
0 Posts
No on both counts.
What intake are you running ? It more than likely has the stud holes in it for both style carbs, and if not...they make an adapter.
Here are a couple examples sir. See the extra holes ?
What intake are you running ? It more than likely has the stud holes in it for both style carbs, and if not...they make an adapter.
Here are a couple examples sir. See the extra holes ?
Last edited by tinman565; 06-12-2011 at 09:21 PM.
#18
Registered
Join Date: Oct 2010
Location: Holland, MI
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
Have you watched the carb as it goes thru this cycle? Does the choke flutter and then close making the engine die?
I had this same situation on a truck I used to have with a marine q jet... Zip tied the choke open and no problems...
I had this same situation on a truck I used to have with a marine q jet... Zip tied the choke open and no problems...