Go Back  Offshoreonly.com > Technical > General Q & A
k planes and hyd. steering >

k planes and hyd. steering

Notices

k planes and hyd. steering

Thread Tools
 
Old 06-04-2013 | 04:15 PM
  #1  
Thread Starter
Registered
 
Joined: Aug 2009
Posts: 410
Likes: 0
From: CONCORD, CALIF
Default k planes and hyd. steering

Over this past winter I installed an m3 procharger on the 502 I built last year. The boat ran a consistent 83 mph on gps with a b&m 250 blower last season. I also installed full hyd. steering, a bblades 26p bravo one and am waiting in the 12"x17" Eddie marine k planes to replace my factory Bennett trim tabs. The steering and k planes were done for safety issues. I'm hoping its been a good investment due to the cost!
mustangmark is offline  
Reply
Old 06-04-2013 | 05:52 PM
  #2  
Randy Nielsen's Avatar
Gold Member
10 Year Member
Gold Member
 
Joined: Jan 2011
Posts: 1,482
Likes: 0
From: Omaha Ne
Default

I'm with ya there, I am doing the same with my project. It has been so long since I've driven the boat I will have to relearn how to drive it but anything is better than the way it was. Randy
Randy Nielsen is offline  
Reply

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.