502's with roller cams have some saltwater spots on them, Replace or run?
#1
502's with roller cams have some saltwater spots on them, Replace or run?
502's with roller cams have some saltwater spots on them, Replace or run?
They look like black spots and and are deep enough to slight catch my nail on them. Any one have any experience with these?
Thanks
They look like black spots and and are deep enough to slight catch my nail on them. Any one have any experience with these?
Thanks
#3
Registered
catch a nail,,time to replace.
#6
Registered
iTrader: (2)
Only time i have seen that was lack of proper pickling or cam was in a bath of milkshake everything else will actually look decent but a few spots on the cam where the roller was under pressure on a lobe that was pointing up . Sucked worse when the cam cost more than a set of pistons .but the prices seem to have come down on the gm crate grinds