Optimal Squish
 

What would be the optimal squish range for a 454 NA build? AFR cyl. heads 10 to 1 compression.

Thanks

Jeff

With good parts .035 would be safe.

Ditching the blowers Jeff?

No blowers for me. Can't afford what I have now.

.040

Keep in mind that .035 is the minimal safe piston to cylinder head clearance. I like a little more of a safety margin myself... mine will go together at .044 (piston .005 in the hole and a .039 gasket). But then again, mine will be blown so a tight quench isn't really necessary.

Just my thoughts... by far no expert.... just my experiences.

I've got less than that on my 632

Less than the minimum? If so, can you elaborate on why? Mine at .044 is still considered tight. Books and articles I've read on this subject say that the tighter than the minimum isn't necessary. Just trying to understand is all.

quench/squish supports combustion process by squeezing the charge into the chamber where the spark occurs, also has a cooling effect as the quench area runs cooler than the rest of the combustion area... this will allow for a higher compression ratio to be used and aid in the quality of combustion achieved... properly designed quench is like upping the octane, promotes a better burn!!

"Zero" decking the block will allow tuning quench with the head gasket, the proper spec for desired quench is a debate that's been around since Chrysler was a cowboy!!! compression ratio and chamber design are factors but on average .035-.060 what I've seen in the field