I found them :D:D

Bams super computer spit out a dealer in Marryland that had two of them. I got both :D:D

Jon

Cool, when you get them take measurements and post them incase anyone needs some made in the future :D If you could please! :D

I will try and remember to do that. I got the two that they had. I only need one but got the second JUST IN CASE!!!! :D:D

Jon

pilot for trs merc trans.
 

Some one call me on Monday, I think I have an aftermarket part number in my tool box. Better call me though, I might forget after a weekend of boating and responsible drinking !!!!

Pwrbt33- John
Offshore Performance
410-827-0200 x-1

i know this thread is from way back in the day but i will give it a shot. has any of thease trs pilot bearings turned up any where? i am in need of two for a trs/merctrans II project. thanks

try merc's nla phone number 1 800 558 6300

98itrwhite, I made some 10 years ago for mine. I made them out of bronze bar stock. thet were half inch thick, 1.700 diameter, center bore (input shaft) .670 . If I remember right I beveled the center bore to take of the sharp edge. I think I still have two of them. I finally went hubers because I kept snapping the inputs and output shafts. Plus the dampner plates are next to impossible to find. I've still got one of those.

Another option may be to contact the guy in Washington that does extensive Merc Trans rebuilds.

http://www.kcmarinetr.com/index.html

Worth a shot!

KC makes them I think.

kc's website say they still have them. i will give them a call thanks everyone for the input:drink: