Originally Posted by ezstriper (Post 4332296)

well at this point, it spun at least one rod bearing, sent metal everywhere, hard to tell form what I see how long ago of or if what rebuilt. inspection of the heads/valves may tell more, why it did it hard to tell, don't take this personally but i have seen good engines destroyed in a short time by dump mistakes(oil lines crossed, carb flooding and killing the oil, etc). Just trying to look at it from the other side of the fence...

Originally Posted by airjunky (Post 4332280)

You have gone this far .. so now lets get that other motor out and apart and take a little look see .
an engine with 4 hours run time can speak volumes about what its going to do with its life ..

Originally Posted by bigboat28 (Post 4332428)

Yes I am worried about the other engine too. I know I don't have the cash to fix 2 and not even sure how I am fixing this one.

Originally Posted by bigboat28 (Post 4332089)

[ATTACH=CONFIG]543331[/ATTACH]

Originally Posted by donzi matt (Post 4332444)

What is his explanation for rust on the cam lobes? Crossed oil lines don't do that, neither does gas washed oil. This thing looks like it was assembled at the bottom of the ocean.