Did I miss a group buy for Medical Marijuana ?

Chillin and shootin the schit ?



Hah !

Anyone have the supplied eagle H beam tightening instructions with arp2000 they can post up ? Maybe icdedppl can post molnars procedure? Curious about difference in them , if any.

Its got to schroom season somewhere, but hey , all good!

eagle with arp bolts gives a torque spec for arp ultra lube,they also tell you how much bolt stretch they need.i use a stretch gauge with a extreme pressure lube.i can,t see any other brand of rods using arp bolts being different.

I found this. MSN, not Google. LOL.
http://www.z1motorsports.com/upload/...structions.pdf

I would still call them (EAGLE) and have them e-mail you the current instructions, in case they've been updated at some point.

what are you trying to figure out buddy?

Awesome thread with some good knowledge.

I was thinking that also, in the end we are all just low budget do it yourselfer guys that want to boat, Dan and I wanted to kill each other 2 years ago, spend a fun weekend hanging out this past summer and had beers on the dock....

I will have to look in my pile of paperwork....
I ordered the 2000 series bolts with mine..

The molnar rod's recommended stretch value for a ARP 7/16 1.800 long bolt, is .007-.0075. Eagles stretch value for that same ARP2000, 7/16 1.800 long bolt, is .064-.068. K1 Technologies spec for same setup, is .068-.072. Scat, doesnt provide a stretch value, just a torque spec.

Why is that? I really don't know, just trying to learn about this topic.