Builder used different cam than specified.
#1
Registered
Thread Starter
Builder used different cam than specified.
I am building a supercharged 454. Forged crank, forged rods, forged 2399 Pistons. I am using rectangle port heads with 2.25/1.88 valves. The blower and carb is stock 525sc stuff. Per mild thunders recommendation, I told my builder I wanted a crane 134561 cam. I show up, pay for it. He then hands me a comp 11-314-4 cam card. I said this is not the cam I speced. He says ya get what I give ya. It is half way between the stock 525sc cam and the cam I requested. He is telling me it should make 610hp. What do you guys think?
#2
Registered
I wouldn't use the comp cam,not enough degrees on the split,,should shoot for 8-10 degrees and not liking the 106icl or 110ls.I'd be looking for a used hp500efi cam,but thats me.
#3
Registered
Thread Starter
He builds a lot of marine engines, but it's not what I wanted and I wanted a bit bigger. I am just unhappy with quite a few things with the builder.
Last edited by 79formula; 01-16-2016 at 05:10 PM.
#4
VIP Member
VIP Member
Join Date: Aug 2010
Location: Stockton, CA
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
It is supercharged so it will be fine . I agree with stupen though especially if it was normally aspirated as the crane would be better with later closing .
You would have thought you'd get at least a phone call.. Ego engines inc??
You would have thought you'd get at least a phone call.. Ego engines inc??
#5
Registered
Thread Starter
He added $1000 to my bill with only one call to add a cam. And the cam was specifically 134561. He also said he would match summits prices. Everything was marked up.
#6
VIP Member
VIP Member
Join Date: Aug 2010
Location: Stockton, CA
Posts: 153
Likes: 0
Received 0 Likes
on
0 Posts
Disapointing .. But it will be a good combo and the bill will be long forgotten when your hearing it run..
Is this a freshen? Upgrade? Before and after post will be good
Is this a freshen? Upgrade? Before and after post will be good
#8
Registered
Thread Starter
It is a long block freshen with the addition of a supercharger. i have a very disorganized thread going already. I am having the motor dyno tuned at the builders shop. I know for a fact, the cam I picked makes 590hp in my setup. I am gonna give his recommendation a try. But if it falls short I am gonna be disappointed.
#9
Registered
Thread Starter
That was my feeling. Right or wrong, it's what I requested. Another things is I had my head guy build my heads with springs to fit the cam I specified.