Bringing up an old thread...just installed engines.

Stock 500efi setup

Port engine starts fine and no alarms.

Start starboard engine runs fine then 30 seconds later we get a beep beep beep beep. No pattern just a beep beep beep. We tested drive bottle by disconnecting the port engine it gives a different beep pattern. 2 beeps pause then 2 beeps.

Tried disconnecting and re connecting oil pressure senders. No dice.

Hooked up rinda tool. Says it's a general engine alarm type 1. With no other fault codes.

All guages are reading perfect invluding oil pressure, water temp, oil temp, etc

stumped on this one..anyone have any ideas?

read all my posts here and I was not getting mad about the springs in the other thread. ^^^^^^

http://www.offshoreonly.com/forums/g...-mefi-3-a.html