any jet ski tech's here
06-01-2016 | 12:28 PM
#6
Were doomed!
Joined: Oct 2000
Posts: 7,098
Likes: 1,396
From: Chicago, IL
There should be a paddle wheel on the back end of the ski....on my GTX its on the ride plate on the left rear corner when you are looking at the jet pump from the back.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
__________________
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
-Wally
Money can't buy happiness, but it can buy horsepower. And I've never seen a sad person hauling a$$!
06-01-2016 | 02:31 PM
#8
Thread Starter
Platinum Member
Joined: May 2012
Posts: 11,428
Likes: 3,955
From: Midwest & T-Rock
There should be a paddle wheel on the back end of the ski....on my GTX its on the ride plate on the left rear corner when you are looking at the jet pump from the back.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
Also if you had your MPEM replaced they may not have transferred the information to it for the speedo...also check all your fuses while your at it.
06-01-2016 | 02:53 PM
#9
Registered
Joined: Jun 2004
Posts: 334
Likes: 1
From: Md
06-01-2016 | 02:59 PM
#10
Forum Regulator
Joined: May 2001
Posts: 24,210
Likes: 1,604
From: Worldwide
Just remembered: I bought a Yamaha GP1200 several years ago and the paddlewheel's wire that went up to the dash/computer had a nick in it, and went bad. I was able to buy the whole part on eBay off of a parted out PWC pretty easily; and install it. It worked fine.
