![]() |
Agree that above idle closed loop is fine (I have mine open loop until 1500rpm - NA motor though). I have my idle well tuned 1500 and below. Also, if I do happen to kill an o2 I sort of have a limp home mode. Unlike ez though, I've had good luck with the innovative extender (I lost my fair share of o2's prior to using). I guess it probably comes down to the exhaust system, how much water your introducing into the stream, location, etc.
|
Originally Posted by Baja Rooster
(Post 4472872)
Has anyone here had any good experience with running a closed loop system?
Originally Posted by kvogt
(Post 4472895)
It is very difficult to run closed loop at idle. I run closed loop from 1800 rpm on up.
Originally Posted by CDShack
(Post 4472897)
What's your experience with closed loop at idle. Looking to EFI a set of twin turbo motors and currently thinking closed loop.
Originally Posted by kvogt
(Post 4472921)
I have 5 inch exhaust on my blower motors and you fight sucking back outside air at idle giving you false lean readings on the o2s. If your putting the o2s before the turbos the problem may not exist. I run the Holley Dominators systems with the new v4 software and it works great in closed loop above idle. Also the NTK o2 sensors are more durable than the bosch imo.
|
I've seen the plates under the turbos where they screw in the 02, what causes them to crash at that location. Should be little to no water there? Are they too close to exhaust for fuel condensation to burn off?
|
Originally Posted by Baja Rooster
(Post 4472129)
After playing with my wideband and seeing how much the mixture varies just from the time of day I'd go closed loop if that's an option.
Super Chevy's list. http://www.superchevy.com/how-to/eng...-market-today/ |
Originally Posted by underpsi68
(Post 4472940)
How much variation are you seeing in a/f reading?
|
Originally Posted by ezstriper
(Post 4472755)
snake oil when comes to a boat setup, if you are getting ANY water near the 02 this is NOT going to help, we tried all kinds of stuff like this a while back, only cure was to move to a header tube which worked fine(how accurate no way to tell, but seemed fine) as far as the EFI really need to run with the 02 or at least do ALL tuning with one
|
Originally Posted by Baja Rooster
(Post 4472560)
That was such a nebulous post that all I got out of it is that he likes dick. ;)
:party-smiley-020: |
Originally Posted by getrdunn
(Post 4473010)
No but word around the campfire your ol lady sure does. Now that is NOT nebulous!
:party-smiley-020: |
Originally Posted by Baja Rooster
(Post 4473034)
Well that's certainly no secret! :bananalove: Lol!
|
| All times are GMT -5. The time now is 06:06 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.