Offshoreonly.com - Spun Drive coupler (or whatever the proper name is)?

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Spun Drive coupler (or whatever the proper name is)? (https://www.offshoreonly.com/forums/general-q/341026-spun-drive-coupler-whatever-proper-name.html)

Hey Scott, good luck with all and we love mastiffs too! Great dogs! Had one that played with a bowling ball.

Will have to get a list of tools. To see what you have and what I need to bring. I have funny story sort of. My last out of state boat that I traveled to - I asked the owner about tools over the course of phone calls not once but many. He said he had everything that was needed to work on the engine side. He said without a doubt every hand tool and some power tools "don't worry " was the words about 10 times to make me quit asking.

So I get there and he starts pulling out these small tackle boxes that are mostly filled with Harbor Freight tools . I'm a thousand miles away and was just handed about 15 small tackle boxes filled with HB tools, The look I gave him was priceless. I did bring some of mine own stuff but should nt have listened to him about the tools. Anyways thought it was funny. Note to Scott as well here -

Quote:

Originally Posted by rak rua (Post 4480053)

I get the impression Scott is committed to the boat and determined to see the project through. Sounds like he's now getting excellent advice and If I were a betting man, I'd put down a bundle to say he's going all the way!

Some time before next summer, he'll have a very nice AT with fresh motors and drives, a new transom and probably a new interior and paint job too!!

Scott, you will love your boat, it will be awesome and you'll never get back what you've spent. Welcome to the real world of go-fast boats. :):)

RR

Does anyone ever get money spent on a boat back?...it may happen on rare occasion, but be real :-) Since I was 6 (LBJ era) it was drilled into my head that a boat is simply a hole in the water you pour money into...it is al a matter of degree.

Quote:

Originally Posted by BUP (Post 4481679)

John - I suspect i may not have all that you need, I have basics and my only HB tool is a borescope :-) I will attempt to acquire what I don't have (e.g. I don't believe I have any yspecialty tools). Nomatter what I have or don't have, you will not be surprised.

I have 2 pair of vice grips (the deluxe harbor freight ones with the rubber grips) a hammer and a reversible (flat head one end philips on the other) screwdriver....

What more could one need??

^^^^^ U bet me to it ^^^^^ ok then a tie wrap cutter tool - Have them

5200 and caulk gun for this one

Quote:

Originally Posted by Brandonb_05 (Post 4481784)

duct tape!

Its DUCK tape, cause it may let loose, any second, and horrible freight.... I did buy some buffing pads from them.:picard1:

Quote:

Originally Posted by BUP (Post 4481792)

^^^^^ U bet me to it ^^^^^ ok then a tie wrap cutter tool - Have them

5200 and caulk gun for this one

Aren't those the chit ! A sparky at work turned me on to these tools.