Timing question (setting initial/total)
"Thought" i had i timing set. When i bumped throttle to 3k rpms the light started bouncing all over. Brand new motor and ran like a swiss watch on the builders stand with and hei dist. Im running msd with a msd box. Did some reading and sounds like it could be due to the msd box and my timing light with the advance dial. Anyone else heard of this?
|
yes,a lot of advance style timing lites will give a incorrect reading.i have a 400 dollar snap on that goes crazy with any msd box.
|
Trade him even up and be happy.
|
Originally Posted by mike tkach
(Post 4497650)
yes,a lot of advance style timing lites will give a incorrect reading.i have a 400 dollar snap on that goes crazy with any msd box.
|
Ebay new around 75.00
|
Originally Posted by SB
(Post 4497656)
Crazy huh ? And a 25+ year old cheaper Craftsman advance dial light doesn't.
|
Well chit. If set the dial to 0 and go off 34 degree mark on the balancer and the tab would that work? Planning on going to the water tomorrow. Ill try to find another light.
|
Also, Make sure your leads from distributor, are wired properly. Purple, does not go to purple. I wanna say on those, its purple(dist side) goes to green, and purple goes to orange(dist side)
|
Originally Posted by cabin fever
(Post 4497678)
Well chit. If set the dial to 0 and go off 34 degree mark on the balancer and the tab would that work? Planning on going to the water tomorrow. Ill try to find another light.
|
Originally Posted by MILD THUNDER
(Post 4497681)
Also, Make sure your leads from distributor, are wired properly. Purple, does not go to purple. I wanna say on those, its purple(dist side) goes to green, and purple goes to orange(dist side)
|
All times are GMT -5. The time now is 03:05 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.