Oil pressure sending unit BBC
#3
Registered
Ayuh,... As far as I know, both SBCs, 'n BBCs have 2 available oil pressure ports,....
The 1 down by the oil filter boss, 'n a 2nd next to the distributor in the aft lifter valley wall,...
The 1 down by the oil filter boss, 'n a 2nd next to the distributor in the aft lifter valley wall,...
#6
Platinum Member
Platinum Member
iTrader: (6)
Its a 3/8 pipe fitting, typically the one on the back side top of the block where the bellhousing bolts up is used for the low oil psi sender for and EFI telling the ECM to alarm, but not always
Last edited by F-2 Speedy; 03-13-2017 at 04:47 PM.
#9
Platinum Member
Platinum Member
iTrader: (6)
gen 6 do
#10
Registered
Thread Starter
So, looking at DanWnetworth's pic and some pics I took of the engine, it appears there are two lines going into the remote oil filter. At the opposite end of where the lines go in, there are two threaded plugs. Would the be a reasonable place to screw in
a mechanical gauge (without having to climb all under the manifolds etc)?
a mechanical gauge (without having to climb all under the manifolds etc)?