crane HI 6M manual needed and/or advise
#1
Registered
Thread Starter
Join Date: Jan 2007
Location: Murrayville Georgia
Posts: 1,817
Likes: 0
Received 891 Likes
on
319 Posts
crane HI 6M manual needed and/or advise
putting back together a set of engines with Crane HI 6M boxes and new MSD distributors but I have no paperwork on the boxes. anyone have a manual or can tell me what the timing settings for each position are? I assume that if using the built in timing curve the dist needs to be locked and phased? if so what do you set the timing to. I assume base timing is taking into account what the curve is for each position setting on the box? hopefully someone knows what I need to do to set these up. thanks
#2
Registered
iTrader: (1)
PM me your e-mail address. I have the instructions in .pdf
#3
Registered
iTrader: (1)
Got your PM and just e-mailed you the instructions.
It is 1MB in size, so give it a few minutes to get to you.
Check your junk mail if not.
It is 1MB in size, so give it a few minutes to get to you.
Check your junk mail if not.
#4
Registered
#5
Registered
iTrader: (1)
#9
Registered
iTrader: (1)
Let's see if the changes to OSO let's me upload them directly without having to e-mail.
Last edited by SB; 07-22-2019 at 10:08 PM.
#10
Registered
iTrader: (1)
Guess it's too big. Oh well.
PM me your e-mail address and I'll try to remember to send it to you tomorrow.
PM me your e-mail address and I'll try to remember to send it to you tomorrow.