Bellhousing or O ring ?
#11
Platinum Member
Platinum Member
iTrader: (6)
The in house guys are trying to get deep into your pocket, as AD has pointed out looks like this can be fixed with a little work and not much cost
#13
Registered
Thread Starter
Join Date: Mar 2001
Location: BIrmingham, MI, USA
Posts: 425
Likes: 0
Received 0 Likes
on
0 Posts
My fault i didn't see the link .. i do now. Ok should i flatten that stuff on the out-drive itself with a file ?
Last edited by powerqrudy; 07-20-2017 at 09:14 PM.
#15
Platinum Member
Platinum Member
iTrader: (1)
yes, while oil fitting is out dress the surface of bellhousing, if its gouged bad from prying (i cant tell from your pics on myphone) you could jb weld and file the surface worst case scenario
#16
Registered
Thread Starter
Join Date: Mar 2001
Location: BIrmingham, MI, USA
Posts: 425
Likes: 0
Received 0 Likes
on
0 Posts
Arctic friends, yes i got some Magnatex ..or something like that. I will be looking at it today after work.
Love the knowledge of this board, and the willingness to share.
THANK YOU TO ALL !
Love the knowledge of this board, and the willingness to share.
THANK YOU TO ALL !
#18
Platinum Member
Platinum Member
iTrader: (6)
Next time count the nuts in in your hand before prying ....lol...........good luck