Joepaakk

Bought this 1989 baja 226 sport this last May 2017 and have had problems since.. won't plane out with more then myself in it unless people sit in cubby, real nice shape interior wise and runs great, 500 hours on motor, 21 stainless 3 blade prop, does NOT have trim tabs, new into the baja world and getting frustrated, its trimmed down as far it can go.. could the styrofoam be waterlogged? Any other thoughts?? Boat sat for a 2-3 years before I got it, had to go through whole fuel system... Not wanting to tear up the whole floor and inside of the boat and unravel more headaches.. any feedback is great thank you!

Crude Intentions

iTrader: (1)

What power? Verify prop. Have you done a compression check? Tune up? Verified timing?

Joepaakk

I have not done a tune up or compression test, boat does 55 mph once on plane, I figured if it had low compression it wouldn't run well, just trying to brainstorm for spring time when it comes outa storage

Joepaakk

Boat has a 454 magnum

Crude Intentions

iTrader: (1)

That should have no problem turning a 21. I'd start with the simple stuff and tune up check compression. That thing should pop out of the water with a big block and a 21.

Joepaakk

Definitely have to in the spring thanks for the advice !

Crude Intentions

iTrader: (1)

Also verify your drive is trimming all the way in. Don't just go by a gauge. That would make a huge difference too

dcb

Dont forget to check the celery stick on the drive trim rams - if backwards will prevent drive from trimming all the way down.

AllDodge

iTrader: (1)

How many rpm's you turning at WOT with just you?

Baja Rooster

iTrader: (1)

A 454 mag should launch that thing like a surfboard.