Let's hear cam suggestions
#11
Charter Member # 55
Charter Member
The 139671 is the 525EFI cam. It will have slightly better manners around the dock.
I don't think you'll see any big differences between any of the ones you posted. I'd prob go with the 525EFI cam.
I don't think you'll see any big differences between any of the ones you posted. I'd prob go with the 525EFI cam.
#12
VIP Member
VIP Member
Thread Starter
Care to elaborate?? is there a bigger/better option I didn't post?? those were just the 2 I saw close to the 741 that was recommended??
Thanks!!
Thanks!!
#14
VIP Member
VIP Member
Thread Starter
Soooo holy Christ is this “stock”??? This thing sounds nasty!!
#15
Registered
iTrader: (3)
My cam is similar to 525efi cam. Its a crower 236/245 , .629/.632, 114lsa . 468ci. Ive ran it with 177 blowers, 250, and 420 blowers. Sounds good , and idles well. With dart 308s and cam installed at 110icl, peak hp was at 6000-6200. With eq heads that flowed better, and 114icl installation (4* retarded), it pulled to 6500rpm. Blowers will typically raise the operating range of a cam, esp a decent sized one.
i defintely would not go smaller if you want to make some steam down the road.
i defintely would not go smaller if you want to make some steam down the road.
#16
VIP Member
VIP Member
Thread Starter
Yea I def plan on upping boost and power down the road...when the 6-71 goes on I'll cross that bridge and yea I don't want to have to do a cam swap when I make that transition
#17
VIP Member
VIP Member
Thread Starter
Also spoke with the engine builder this morning and they agree those cams will work well...he is doing some research and I have to call him tomorrow morning with some other options from different manufacturers just so I know all the options
#18
VIP Member
VIP Member
Thread Starter
Supercharger/Nitrous Retro-Fit Hydraulic Roller Cam - Chevrolet Big Block 299/304 - Lunati Power
opinions on this one?? its like half the cost of crane....
opinions on this one?? its like half the cost of crane....
#19
VIP Member
VIP Member
Thread Starter
https://www.crower.com/camshafts/chevy-396-454-hydraulic-roller-cam-253hr260-late-model.html
crower option...maybe a little big for my needs
crower option...maybe a little big for my needs
#20
VIP Member
VIP Member
Thread Starter