502 rebuild
10-18-2018 | 08:01 PM
#11
Registered
Joined: Nov 2009
Posts: 4,198
Likes: 500
From: KY
10-19-2018 | 12:21 AM
#12
Charter Member # 55
Joined: Oct 2000
Posts: 20,241
Likes: 2,490
From: Omaha/LOTO
10-19-2018 | 12:57 AM
#13
Registered
Joined: Oct 2007
Posts: 8,439
Likes: 93
From: yorkville,il
10-19-2018 | 07:34 AM
#14
Registered
Joined: Jan 2006
Posts: 3,861
Likes: 793
From: St. Pete Beach, FL
lol I was thinking the same thing. I thought the forum was off his dick.
If you want to hear someone wax poetic about “cylinder filling” he’s your guy. What you’re actually going to get: afr heads and a crane 741 cam with more aggressive ramps. (Doesn’t seem wise for valvetrain life to me?)
If you want to hear someone wax poetic about “cylinder filling” he’s your guy. What you’re actually going to get: afr heads and a crane 741 cam with more aggressive ramps. (Doesn’t seem wise for valvetrain life to me?)
10-21-2018 | 05:26 AM
#17
Registered
Joined: Oct 2004
Posts: 2,670
Likes: 651
From: Clayton NJ
10-21-2018 | 12:16 PM
#19
Platinum Member
Joined: Jun 2004
Posts: 7,317
Likes: 1,037
From: frankenmuth michigan
If you use the mpi intake, cut down and blend the runners to match the plenum floor , send tb to tpis and have them take it from 60 mm to 68 mm. Port match the intake. If your going carbed, dont run out and buy a vic jr, buy a edelbrock performer rpm, it will kick the vic jrs ass from 5800 down and for the 40 ft lbs tq and hp the vic jr gives up, the 5 hp you gain at 6000 isnt a good trade off!
