|
Merc 6.2
https://cimg0.ibsrv.net/gimg/www.off...16ede10bc2.png Has anyone seen these before ( it’s not a butt connector) it is wired inline to the thermostat sending unit. It appears to change the temp reading by 10 to 15 degrees. It’s on a 2006 mercruiser 6.2. Thanks |
measure it w/ an ohm meter and see if it has a resistance value.
|
It might be used as a pull up resistor.
|
The problem is it’s broke in half, so I won’t be able to pull the ohms |
Cut the covering off. See if it is a resistor inside. If so the resistance will be the color code on the outside.
It might be 2000-2200. |
So this resistor will pull the temp reading down on the gauge to match what the Rinda shows it’s reading? |
^^^^^^^^^^^ Underpsi posts --- Bingo .
|
So where can you get them, or is it possible to change to a different temp sending unit and eliminate the resistor? And thank you. |
U need to post your engine serial number and which 6.2 do you have
|
Thank you, I will get the serial number, I’ll probably reply with it tomorrow unless I come up with it on some paperwork work I have here. |
| All times are GMT -5. The time now is 06:53 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.