Mercury 522EFI MAP sensor code. replaced still code.
#1
Platinum Member
Platinum Member
Thread Starter
Mercury 522EFI MAP sensor code. replaced still code.
HELP ME PLEASE!!! 525efi pro's out there!! Having a warning alarm go off on my 2006 fountain w/ 525efi's. I scaned pcm and it says code 15 which is MAP sensor circut high, somtimes i get a code 16 which is map circut low. I have swaped MAP sensor from other motor and same code appear so its not a bad MAP sensor. when i unplug it alarm goes off and thows same code too. Sensor is reading same as barametric, ket on engine off so i know its getting reading. Alarm goes off every min or so. I checked pins and conector going into PCM555 and all look good. Any ideas? Im new to the 525efi's and help would be great. Thanks in advance.
#2
Registered
iTrader: (1)
when i unplug it alarm goes off and thows same code too
I don't have a wiring diagram for your motor, hope someone else does to give you a pin out. Need to use an ohm meter and check continuity with each wire.
Do you have 5V at the connector, and move it around to see if it changes?
#6
Banned
iTrader: (9)
Thanks for putting my name on this.
he has already called me Friday nite and today. There is a reason whythe PCM failed and that will be fixed per my instructions. We are all good here, Ill update this as we go here.
There is a lot to these internal repairs of all these marine 555 ecms / pcm s that the few others are not doing. Really needed to put that out there for the fact of the matter. . ..
he has already called me Friday nite and today. There is a reason whythe PCM failed and that will be fixed per my instructions. We are all good here, Ill update this as we go here.
There is a lot to these internal repairs of all these marine 555 ecms / pcm s that the few others are not doing. Really needed to put that out there for the fact of the matter. . ..