|
Originally Posted by flashgordon
(Post 4728640)
what are webster???
rock shaft system? or its a stud girdle system.... i had jomars on my super gas car... again i was going to put stud girdle on my motors, and engine builder said , i dont need and stud girdle are tuff on aluminum heads my isky cams are 714 lift,,,dont know spring pressure. |
Originally Posted by Nbn
(Post 4727389)
Can I make the Keith Eckard two piece valve covers work with Webster stud girdles and have enough clearance with the three-quarter or 1 inch valve cover spacers does anybody have any experience with it? Motors are
world block low decks and world heads cmi etop exhaust with roller rockers looking to add space for Webster girdle doable ? we have same exhaust i think. maybe time to look at stud girdle ...... jomar is another brand,,ran jomar setup before on super gas car. |
Originally Posted by F-2 Speedy
(Post 4728647)
I don't even understand this statement...@ that lift your running a solid roller ? is the reason for valve adjustment.....Webster is the manufacturer in Cali....not to hijack the OP's thread
so,,,,?????? yes sorry to hijack OP thread also... |
| All times are GMT -5. The time now is 05:21 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.