500 efi thermostat housing
#1
500 efi thermostat housing
I’ve noticed some mercury 500 efi’s running only two water hoses to the exhaust instead of four. I’m looking for a thermostat housing to accommodate this style of system. My boat has stainless marine exhaust where the water ports are looped from the header to the risers. So any input would be great so I can figure out which t-stat housing I would need. Thanks
#4
Platinum Member
Platinum Member
iTrader: (6)
That ^^^^^^ is for a 502 mag mpi not a 500....you may run into clearance issues, you can block off the other outlets if not needed
#5
Registered
iTrader: (1)
Many perf exhausts came with, or offered optionally, y’s to put on each side the 2 hoses into one.
#7
Registered
iTrader: (1)
See :
https://www.eddiemarine.com/image/da...structions.pdf
Holy bag they are expensive now. Maybe you can find some others ?
https://www.eddiemarine.com/image/da...structions.pdf
Holy bag they are expensive now. Maybe you can find some others ?
#9
Platinum Member
Platinum Member
iTrader: (6)
why dont you post a pic of what you have and what you're trying to do, I just rebuilt a pair of 500 EFI's and used the GLM thermo housings, had to do a little modification to them, they make a block off plate for the other 2 hose connections
#10
Platinum Member
Platinum Member
iTrader: (2)
The 502 MPI style of housing creates a lot of water pressure. Block pressures at speed have pegged my 35 PSI gauges. You may need to add water pressure relief valves.