warped intake valves
#1
Registered
Thread Starter
Join Date: Apr 2012
Location: Cawker City Kansas
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
warped intake valves
502 mpi engine with only 45 hours since heads were redone but now everyone of the intake valves are warped. Any ideals what causes it? Machinist said they are the heavy duty valves.
#2
#3
Platinum Member
Platinum Member
Let’s see one. Can you post any pics?
#4
Registered
What do you mean warped? Bent?
#5
Registered
Thread Starter
Join Date: Apr 2012
Location: Cawker City Kansas
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
#8
Registered
Thread Starter
Join Date: Apr 2012
Location: Cawker City Kansas
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Block was just cleaned up and make sure both deck heights were the same. I don't remember how much off the heads but not much and original heads. I put cam in straight up and mocked it up and measured valve clearance but that was 4 years ago and don't remember how much
#10
Registered
I have seen that in a lot of small block heads but cant say I have ever seen it in Big Blocks. They are tuliped which I suppose some people call warped. I know if you are getting water in the cylinder they will definitely do it. When I do a set of small block heads i almost always put stainless intakes in them.
I think you need to have your machinist verify if they are "warped" or "tuliped" big difference in the causes. And a picture would be nice
I think you need to have your machinist verify if they are "warped" or "tuliped" big difference in the causes. And a picture would be nice