As always Walter you are on top of it ... yes speedo now to gps,
old single ram now to dual full hyd helm with Imco box and wing plates off box for rams, 2 small platforms will stay.
All this along with painting transom should really clean up the back for that all buz attitude and look!!!

fill primer

box final fit up

man you guys are cruising along nicely! :D keep it going!

Thanks bro, Taking boat to booth sat to paint transom. Then it can go together for good!:D

Painted drive...

Fully prepped transom

1st coat of blue...

Blue transom turned out great...

#2...

How are you planning on running your steering lines? I ran mine through the box. Made for a cleaner install, but it sure gets crouded!

Thru transom fittings, standard Imco kit.

My good friend Dan, his turn this time around. He has done mucho work on our Cig, glad to reciprocate.

Looking great guys!

Back to work...

Shaft and coupler...

wing plates, rams and lines done

lt side

It's looking great!

Zoom It looks like fun! did you run it with the same power to get some comparable numbers before and after the extention box? How much power do you run in that boat?Greg

Yep, Procharged 502 7 lbs of boost, ran like 88. So we will have a good comparison. Box should help the attitude and carry the bow
better.
Any one want to speculate, I would be curious. Nose cone? Box?
Fresh motor, base 502?

Zoomn,

Nice project!!!!! That painted lower looks fantastic. Where was the spray & bake done? Keep that thing trimmed up on the Chain!

Keep those pics flowing.

Mark S.

Thanks BL, painted at a friends shop, have alot in the auto/boat industry. Lower turned out great.
More pics to follow as we progress.
Dean

100+ :cool:

He wishes:eek:

Busher, thats about what we figure...

Zoom,

Is that a 3" lift? Are you putting on the shorter drive as well? Greg

Neutral, going to go with shorter lower if required.

The math works out pretty good, might be okay as is.

Helm, lines etc all done.

cleaned up side rigging...

In the air...

Motor back in...

Looks like you almost ready for the hose....:D

"LQQK'N Good Brother Man"! How's Dan the Man Hang'n in there and did you get that shaft problem solved? I'll call you in the morning.

Also, if you have time bring me the table and cooler trim piece. I am working on my rig this weekend.

Ron~Da~Voo

Yo, Back For More is that new art work I see on the side of your rig?

Yeah baby!
The 10 year anniversary paint job for 2003.
;)

getting closer

polished diamond plate

Better mount a set of PORT and STBD coolers back there.
Looks great with the plate!

been working, just not posting...

fuel, oil etc...