How to Identify my motors ???
#1
Registered
Thread Starter
Join Date: Jul 2002
Location: Hudson Valley
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
How to Identify my motors ???
I'm told they are stock mercruiser 440 H.p. Are there any numbers or any other way to find out what they were maufactured as....????
I'm getting ready to install these (rebuilt 5 years ago and never fired) motors, any thing i should look for?
i have them on motor stands, i pulled the oil pans to ck them out and everything looks nice and fresh, new pistons, rings, rods , rod and main bearings, and cam... any advice would be very helpful thx..
Also i would like to freshen the paint on motors whats the best paint out there for heat resistence??? thx again
Dennis moore if your out there you can chime in any time....
I'm getting ready to install these (rebuilt 5 years ago and never fired) motors, any thing i should look for?
i have them on motor stands, i pulled the oil pans to ck them out and everything looks nice and fresh, new pistons, rings, rods , rod and main bearings, and cam... any advice would be very helpful thx..
Also i would like to freshen the paint on motors whats the best paint out there for heat resistence??? thx again
Dennis moore if your out there you can chime in any time....
#3
Registered
Join Date: Dec 2001
Location: Rapid City SD
Posts: 809
Likes: 0
Received 0 Likes
on
0 Posts
XCAV8,
Try this out. I'm not familiar with that engine, but maybe this will help.
http://www.mortec.com/
Try this out. I'm not familiar with that engine, but maybe this will help.
http://www.mortec.com/
#4
Registered
Join Date: Jan 2001
Location: ST. Louis, MO, USA
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
On the front of the motor, either above the timing cover or under the right cylinder head, will be a number. That number indicates the Merc number for the engine. This indicates the year, hp, rotation, etc.
Check out this link for that info:
http://www.marinemechanic.com/site/page131.html
There is also a block casting number on the left rear. This will indicate what the block was cast as, 454, 4 bolt, etc.
This link covers that:
http://www.mortec.com/
Gary
Check out this link for that info:
http://www.marinemechanic.com/site/page131.html
There is also a block casting number on the left rear. This will indicate what the block was cast as, 454, 4 bolt, etc.
This link covers that:
http://www.mortec.com/
Gary
#5
Registered
Thread Starter
Join Date: Jul 2002
Location: Hudson Valley
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
Thanks gary, that is an awsome page lots of info......
my motors are not 440's at all, xs code means 330 h.p.
i must say i'm bumming right now.....
i guess i should have cked this out before i bought the boat...
live and learn i guess.....
my motors are not 440's at all, xs code means 330 h.p.
i must say i'm bumming right now.....
i guess i should have cked this out before i bought the boat...
live and learn i guess.....
Thread
Thread Starter
Forum
Replies
Last Post
302Sport
General Boating Discussion
22
09-19-2008 01:19 PM
32 thunder
General Boating Discussion
17
07-09-2005 10:09 AM