Does anyone have prints on an engine alignment tool? I'd like to make one myself if i can. Thanks, Eric.

I'm near Anchor Bay if you want to borrow one to duplicate.

Thanks for the offer lee if i head up that way this winter maybe i can stop by and take some dimensions.

No problem, I'm also in Dearborn everyday.

I just use an old upper shaft, if you have a drive detached just use that as your pattern.

here ya go!

that dont look so good online......email me and i'll email you the file i have on it....it prints out good

[email protected]

All I've seen have been the drive spline shaft (without the u-joint) to which has been welded an extension rod so you don't get greasy when you slide it in and out. Pretty simple.

I redrew it in cad from the picture wally sent me so if anyone needs it I can email it to them.

ofshore,
Please email me a copy.
Thanks,
Phil
[email protected]