HP500 EFI owners - clearance measurement
03-30-2004 | 12:25 PM
#1
Thread Starter
Registered
Joined: Feb 2001
Posts: 1,519
Likes: 31
HP500 EFI owners - clearance measurement
Hi guys:
I could use a little help involving you and your tape measure. I am designing a supercooler for this engine and I need to know how much room you have at the front starboard corner of the engine. The clearance needed involves the back seat bulkhead and the underside of the engine hatch. The attached drawing shows the area of concern, with the extreme corner circled in red.
I have the engine mocked up so it's easy to measure clearances to engine parts, but I don't have access to the many boat models with this engine installed.
Any measurements and photos greatly appreciated!
Tom Robinson
(416) 709 - 8714
I could use a little help involving you and your tape measure. I am designing a supercooler for this engine and I need to know how much room you have at the front starboard corner of the engine. The clearance needed involves the back seat bulkhead and the underside of the engine hatch. The attached drawing shows the area of concern, with the extreme corner circled in red.
I have the engine mocked up so it's easy to measure clearances to engine parts, but I don't have access to the many boat models with this engine installed.
Any measurements and photos greatly appreciated!
Tom Robinson
(416) 709 - 8714
