Oil Bath Hubs ???
#1
Registered
Thread Starter
Join Date: Jan 2003
Location: Kingman, Arizona
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Oil Bath Hubs ???
Has anyone ever converted standard grease hubs to oil bath hubs on a boat trailer?
They run so much cooler but can you keep the water out?
They run so much cooler but can you keep the water out?
#4
Registered
Join Date: Feb 2004
Location: Smith Mountain Lake, Virgina
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
Re: Oil Bath Hubs ???
I Have Sold 3 Trailer With Them And The S###k! One Trailer Brakes Got Melted The Cheap Plastic Cap Then Seized Up. Water Get In Them And Don't Bump One It Will Break Off. And Finally You Can Always Find A Bearing Cap On The Weekend! Safe Boating!
#5
Registered
Join Date: Jan 2004
Location: Saint Petersburg Fl
Posts: 1,571
Likes: 0
Received 0 Likes
on
0 Posts
Re: Oil Bath Hubs ???
I hear the oil baths are junk too. Had a buddy that had them and he had a seal fail and toasted a bearing on a 8 hr drive. Lucky for him he had a tandem trailer and could limp it to a shop. I think a good marine grease and maintance is all you need.
#6
Registered
Re: Oil Bath Hubs ???
I replaced 1 of my 4 wheels w/ oil bath because West Marine was out of stock of the grease ones for my trailer. over 1000 miles so far and no leaks and no water. The oil did turn darker though but I assume this is normal because it rolls free and no noise.
Roby
Roby
Thread
Thread Starter
Forum
Replies
Last Post
Gene in NC
General Boating Discussion
0
08-21-2006 09:27 PM