customryder

anyone know a trick to get drive locks off with out the key? can you get keys? I bought a use boat without the keys. Thanks Jeff

mrv8outboard

check with you local marine shop. they should be able to get new keys. i have gotten them before for customers.

US1 Fountain

iTrader: (1)

I've used a dremel with a cut off wheel and cut the casing in half on McGards locks before. Then just a pair of pliers to undo the nut.

cuda

I've gotten them off with a GOOD small pipe wrench.

ratman

use only a little explosive.. or just cut it in half with a cutoff wheel. note it will be quicker and a lot more fun using an explosive charge. please vidoe the eplosion for a how to video for other members or america's funniest home videos. ratman

marinetrans

Snap-On 7/16 12pt 3/8 drive deep socket.Use a hammer and drive it in there.Works like the original key.Have to use Snap-On,everything else splits.

cuda

I hadn't tried it, but I was thinking along the same lines as Marinetrans. I'd use a cheap impact socket though.

scottc

air chisel, catch the edge and vibrate it around to loosen it up. I do that on striped nuts also

obnoxus

Or, a 3/8 12pt socket will pull the stud and lock outf. Then just put back and you still have the " lock "

JIMG

If you have a key from any other mcgard lock, just put it in a socket on an extension, rap it good with a hammer, put the ratchet on without disturbing it, & spin it off. Works every time.