O ringed block
 

Are there any disadvantages in a oringed block? I am considering purchasing one that is oringed and i am not running a blower and i am only building a NA 540 9.7 :1 with afr 315 cnc heads and a roller hydraulic cam .613 .629 112 lsa and 236 244. should i stay away?

Re: O ringed block
 

The Important Thing To Look At Is Weather The Oring Job That Is There Will Work For The Gasket Your Going To Use If Not Then You Would Have To Machine It Out The Only Gasket Fel Pro Makes With A Full Round Bore Is The Pro Stock Gasket I Think Its 17095 If Im Not Mistaking Don't Quote Me There . Otherwise You Can Use A Copper Gasket Which I Do Not Recomend For Marine Use. Good Luck Laz Mesa

Re: O ringed block
 

Deck it and run a good gasket, Fel-Pro or Cometic.

Re: O ringed block
 

If you decided to not use the o rings and had the block decked, wouldn't decking that much material off the top of the block create problems with getting the pistons t.d.c. correct? You may have to go with a custom pin location to get the quench area right. That may also create alignment problems with the intake manifold.

Re: O ringed block
 

It might depending on how much material is still left on the decks. I wouldn't take it past a 0 deck hgt. O-ring grooves are not very deep.

Re: O ringed block
 

You may want to check if it has already been decked then O-ringed.

Re: O ringed block
 

thanx and i gave up on this block it is just not worth it.

Re: O ringed block
 

Why is a copper gasket not recommended? Just wondering.

Re: O ringed block
 

1) salt will kill it.
2) hard to get a proper seal on the water passages, at least a proper seal that stays good. Also gotta retorque them.