Serpentine pulleys from 502 Procharger install
03-05-2005 | 02:14 PM
#1
Thread Starter
Registered
Joined: Apr 2004
Posts: 48
Likes: 0
Need stock serpentine pulleys from 502 Procharger install
I'm rebuilding a 502 MPI back to normally aspirated from procharger set up.
I am missing the crank, waterpump and tension idler pulleys and bracket to go back to the stock configuration on this motor.
Is there any other sources other than mecrury to buy this stuff?
Is this the same as late model GM truck stuff?
Any idea's?
I am missing the crank, waterpump and tension idler pulleys and bracket to go back to the stock configuration on this motor.
Is there any other sources other than mecrury to buy this stuff?
Is this the same as late model GM truck stuff?
Any idea's?
Last edited by revomaniac; 03-05-2005 at 04:56 PM. Reason: Bad wording
