Offshoreonly.com - Hydraulic Roller Setup for 502

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- General Q & A (https://www.offshoreonly.com/forums/general-q-20/)

- - Hydraulic Roller Setup for 502 (https://www.offshoreonly.com/forums/general-q/98162-hydraulic-roller-setup-502-a.html)

vandeano

03-12-2005 01:54 AM

Hydraulic Roller Setup for 502

I have a 1991 502 Mag stock engine with Eddie marine exhaust. I would like to change it over to a Hydraulic Roller setup.

I would really appreciate any advise on which type of roller setup would be good and not have to worry about water reversion with my type of exhaust. :drink:

Pat McPherson

03-12-2005 07:25 PM

Re: Hydraulic Roller Setup for 502

Most have recommended the Crane 731 or 741 in the past.
If you have the short captain's call type riser then don't go bigger than the 731.
Either way, you should have your heads gone through because of the added lift.
It would not be a bad idea to freshen the whole engine because it's going to make a lot more power... :D

50boat

03-12-2005 07:34 PM

Re: Hydraulic Roller Setup for 502

:D :rolleyes: call travis.. he has 2 cams from a hp 500 that are perfict condison 8163804732.. went to 540 cu u-dow-u- do750hp

All times are GMT -5. The time now is 03:45 AM.