Hydraulic Roller Setup for 502
03-12-2005 | 01:54 AM
#1
Thread Starter
Registered
Joined: Sep 2004
Posts: 362
Likes: 0
From: Torrance, California
Hydraulic Roller Setup for 502
I have a 1991 502 Mag stock engine with Eddie marine exhaust. I would like to change it over to a Hydraulic Roller setup.
I would really appreciate any advise on which type of roller setup would be good and not have to worry about water reversion with my type of exhaust.
I would really appreciate any advise on which type of roller setup would be good and not have to worry about water reversion with my type of exhaust.
03-12-2005 | 07:25 PM
#2
VIP Member
Joined: Oct 2002
Posts: 5,246
Likes: 3
From: Ivoryton, CT
Re: Hydraulic Roller Setup for 502
Most have recommended the Crane 731 or 741 in the past.
If you have the short captain's call type riser then don't go bigger than the 731.
Either way, you should have your heads gone through because of the added lift.
It would not be a bad idea to freshen the whole engine because it's going to make a lot more power...
If you have the short captain's call type riser then don't go bigger than the 731.
Either way, you should have your heads gone through because of the added lift.
It would not be a bad idea to freshen the whole engine because it's going to make a lot more power...
__________________
Patrick
Patrick
call travis.. he has 2 cams from a hp 500 that are perfict condison 8163804732.. went to 540 cu u-dow-u- do750hp
Thread
Thread Starter
Forum
Replies
Last Post
formula31
General Q & A
6
03-19-2002 10:33 PM
