Grand Haven to Muskegon Saturday...
10-16-2008, 06:54 PM
#12
Registered
Join Date: Feb 2007
Location: Fort Lauderdale Beach, FL
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Chicken- If I had you finish my extension box, would it be complete prior to Hot Boat 2012? I rented a building today close to home to work on the boat over the winter. The motor is up to Dick's at More Power for a dyno run. Project Tripple Diggits!!!!! 
What's up for halloween? MR
What's up for halloween? MR
10-16-2008, 10:15 PM
#13
Registered
Thread Starter
Join Date: Oct 2000
Location: Spring Lake, MI
Posts: 328
Likes: 0
Received 0 Likes
on
0 Posts
Give me a date and it will be done by then...
Why Dick and not Tom? He is much closer!
Not sure on Halloween! We are suppose to do a party then off to down town. Are you still with blondie?
Looks like sunday has a possibility for more boating. You should have went last weekend.
Call me!
Why Dick and not Tom? He is much closer!
Not sure on Halloween! We are suppose to do a party then off to down town. Are you still with blondie?
Looks like sunday has a possibility for more boating. You should have went last weekend.
Call me!
10-17-2008, 02:50 PM
#14
Registered
Join Date: Feb 2007
Location: Fort Lauderdale Beach, FL
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
I will call you this weekend. As far as Tom, I heard he can be a little aggressive on the dyno. I had good luck with Dick on my Baja motor. He had it making 570hp with a 502 and cast iron heads. I just want to see what I have, where the best power lies between 5-6K rpm, and have it dialed in. I also told him to throw bearing in it, just cause, it does have 5 or so hours on it.
Food for thought, why not an aluminum drive shaft like a circle track car? Right from the motor, through the box, no carrier, to the drive? I think it is 4", put u joints on each end, bolt to the crank, and connect to the u joint on the drive. Or would the angle be to great without a break in the middle? It would eliminate allot of parts.
Blondie is still around, and you know Halloween is my fav. Hot Dog with katschup anyone? MR
Food for thought, why not an aluminum drive shaft like a circle track car? Right from the motor, through the box, no carrier, to the drive? I think it is 4", put u joints on each end, bolt to the crank, and connect to the u joint on the drive. Or would the angle be to great without a break in the middle? It would eliminate allot of parts. Blondie is still around, and you know Halloween is my fav. Hot Dog with katschup anyone?
MR
Thread
Thread Starter
Forum
Replies
Last Post
dockrocker
General Boating Discussion
12
12-21-2004 02:51 PM
dockrocker
General Boating Discussion
1
06-02-2003 03:26 PM
