Motor or Recommended Engine Rebuilders - Michigan
#1
Registered
Thread Starter
Join Date: Dec 2011
Location: Chesterfield Michigan
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
Motor or Recommended Engine Rebuilders - Michigan
Are there any motor rebuilders in eastern Michigan you would recommend?
I have 502 MPI's and planning ahead to see what my next move is. I have 300 hours...motors/engines in good shape, but I may want to be pre-emptive and get some work done.
Looking for the best shop or one you have used beofre and recommend.
Thanks!
I have 502 MPI's and planning ahead to see what my next move is. I have 300 hours...motors/engines in good shape, but I may want to be pre-emptive and get some work done.
Looking for the best shop or one you have used beofre and recommend.
Thanks!
#5
Registered
Thread Starter
Join Date: Dec 2011
Location: Chesterfield Michigan
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
I'll have to check north bay or dynamic as I'm located right in chesterfield. I'd love the opportunity to add a bit of performance while doing a rebuild.
I have much to research and read on this topic as I'm a novice in the motor department.
I have much to research and read on this topic as I'm a novice in the motor department.
#6
Registered
iTrader: (5)
Its a tough decision to pick a builder thats for sure!
Your engines might go 500+ hours without rebuild but if you want a little more power, and reliability you could freshen them.
Tyler Crocket
Jim Valeko
Dave Wesseldyk "WESCO"
C-Tech Performance
Sterling (very expensive but good and specialize in 700HP+)
I would NOT recommend CK Motorsports/Baker enginering
I would not go over 550hp on any bravo based drive. And don't plan to waste money upgrading drives, just sell your boat before you stick money into the engines and drives and buy something already done.
Your engines might go 500+ hours without rebuild but if you want a little more power, and reliability you could freshen them.
Tyler Crocket
Jim Valeko
Dave Wesseldyk "WESCO"
C-Tech Performance
Sterling (very expensive but good and specialize in 700HP+)
I would NOT recommend CK Motorsports/Baker enginering
I would not go over 550hp on any bravo based drive. And don't plan to waste money upgrading drives, just sell your boat before you stick money into the engines and drives and buy something already done.