50' Hustler winter project
#35
Registered
Thread Starter
iTrader: (1)
Join Date: Jan 2006
Posts: 470
Likes: 0
Received 0 Likes
on
0 Posts
Update
I wanted to post an update it has been too long. I have had a lot of small thing that needed to be addressed it seemed like one after the other and have not had the time to keep up so I finally got a couple of free days to start addressing some of the problems. some take longer than others and going from Trip Bravos to ADS-8 with transmissions is a large project not to mention going from carbs to EFI. Most of the problems were stupid things however not having the time they took forever. My last problem was a tough one and really the only problem with the motor or EFI system. I was using a mag sensor for my crank readings and was getting too much interference. example I would start one motor but get readings on another that was not even running. once we changed the sensors to a Hall type this was corrected and that just happened yesterday. so I was able to get a run in yesterday speed was over 90MPH however my RPMs are all over the place so now I can have my props adjusted. another words my center motor hit about 4200RPM. I will now be able to also dial in my motors as I had AFR all over the place. I'm running very rich now but will do this tune next season. I cannot forget the Rooster it was about 20’ tall from what the guys said in the back seat