new 41 Center Console mold
#12
Registered
Joined: Jan 2007
Posts: 37
Likes: 0
What's going on? I stopped in about a week or 2 ago at the shop. I guess David was at lunch or something, his truck was there and the gate was open.
Anyway, hope all is well, was kind of hoping to see the big boat.
Let me know if you guys need some help.
Mike
Anyway, hope all is well, was kind of hoping to see the big boat.
Let me know if you guys need some help.
Mike
#17
#19
I was there friday and will say the detail going into this boat is unbelievable. The bilge area on an outboard has a liner for storage and beneath that is another liner for trim pumps and rigging. The boat is equipped with large tubes for wiring and plumbing to every location. The cabin door is large enough for 2 people to sit in side by side. The fuel tank is mounted on rubber cushions to prevent rubbing through the tank or the hull and then encapsulated. I have never seen a better fit of a hull and deck joint before either.
This boat is going to be bad!!!
This boat is going to be bad!!!
#20
I was there friday and will say the detail going into this boat is unbelievable. The bilge area on an outboard has a liner for storage and beneath that is another liner for trim pumps and rigging. The boat is equipped with large tubes for wiring and plumbing to every location. The cabin door is large enough for 2 people to sit in side by side. The fuel tank is mounted on rubber cushions to prevent rubbing through the tank or the hull and then encapsulated. I have never seen a better fit of a hull and deck joint before either.
This boat is going to be bad!!!
This boat is going to be bad!!!



