Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   Nordic (https://www.offshoreonly.com/forums/nordic-99/)
-   -   A/C in a heat (https://www.offshoreonly.com/forums/nordic/106577-c-heat.html)

IndianaHeat 06-28-2005 03:14 PM

A/C in a heat
 
has anyone seen a A/C unit in the floor just in front of the anchor locker? looking at putting in a ac unit in ,some how been too hot this year in the cabin, I think the fuel tanks go all the way to the floor so i cant
run ducts under the fuel tank, any ideals or has anyone seen one installed
thanks Bill

Linster 06-29-2005 04:41 AM

Re: A/C in a heat
 
I am just about finished installing in a Flame. I bet I have 60 hours in it. I built a shelf in the V area so I would still have some storage under the unit (6") for long items. I will take some pictures tonight.

Go to Domectic and download the install instructions. I pulled the water and power lines from the pump throught the far outside stringers.

IndianaHeat 06-29-2005 10:13 AM

Re: A/C in a heat
 
Thanks Linster will do......... ill keep an eye out for your pics

Linster 07-06-2005 03:51 AM

Re: A/C in a heat
 
Will take them Thrusday PM, Look Friday

39 Unlimited 07-10-2005 05:45 PM

Re: A/C in a heat
 
Linster, what up with the new motors?

Linster 07-16-2005 12:47 PM

Re: A/C in a heat
 
1 Attachment(s)
Sorry it took so long. Picture of Water inlet. I installed it in the notch transom so it would not interfere with the trailer.

Linster 07-16-2005 12:49 PM

Re: A/C in a heat
 
1 Attachment(s)
Here's how I put the filter and valve to the front of the engines so it could be serviced. The pump is under the batteries.

Linster 07-16-2005 12:52 PM

Re: A/C in a heat
 
2 Attachment(s)
I installed three vents for supply. 1 in the V berth, a 4". Two 3" on each side of the seats. I used the cup holders to the cockpit side of the seats for holes. I used 3 & 4 inch flexible metal duct and wrapped it with a 1/4" foam insulation and aluminum wrap.

Linster 07-16-2005 12:54 PM

Re: A/C in a heat
 
1 Attachment(s)
I installed the controls behind the passenger side seat in the cabin toward the V berth

Linster 07-16-2005 12:57 PM

Re: A/C in a heat
 
2 Attachment(s)
I cut a hole in the V berth under the cushion to get the unit in. I took some 1/4" aluminum and made holders to keep the piece I cut as an access. 50 Hours total to install. It is tight as you know what in there,


All times are GMT -5. The time now is 12:04 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.