driver looking for a seat
#21
A to Z
Platinum Member
#23
Registered
Join Date: Nov 2003
Posts: 701
Likes: 0
Received 0 Likes
on
0 Posts
santa
santa is getting ready to dyno motors. and he told me to f@#k off when i asked him for a supercat??
mike, rob told me last year that i could leave the skiff at his place and he would race it for me so that the boat would qualify for the champ-race at the end of the year.
i had nightmares of my motor being jammed in a garvey and run at 8500rpm with joey telling me that the motor was okay but they had a few problems. ohh by the way heres one of your connecting rods??!!??
mike, rob told me last year that i could leave the skiff at his place and he would race it for me so that the boat would qualify for the champ-race at the end of the year.
i had nightmares of my motor being jammed in a garvey and run at 8500rpm with joey telling me that the motor was okay but they had a few problems. ohh by the way heres one of your connecting rods??!!??
#24
Registered
Join Date: May 2006
Location: Tuckerton, NJ
Posts: 2,168
Likes: 0
Received 0 Likes
on
0 Posts
santa is getting ready to dyno motors. and he told me to f@#k off when i asked him for a supercat??
mike, rob told me last year that i could leave the skiff at his place and he would race it for me so that the boat would qualify for the champ-race at the end of the year.
i had nightmares of my motor being jammed in a garvey and run at 8500rpm with joey telling me that the motor was okay but they had a few problems. ohh by the way heres one of your connecting rods??!!??
mike, rob told me last year that i could leave the skiff at his place and he would race it for me so that the boat would qualify for the champ-race at the end of the year.
i had nightmares of my motor being jammed in a garvey and run at 8500rpm with joey telling me that the motor was okay but they had a few problems. ohh by the way heres one of your connecting rods??!!??
Thread
Thread Starter
Forum
Replies
Last Post
Ryan Beckley
General Boating Discussion
6
09-21-2008 08:44 PM