The World Cup suggestions
10-28-2008 | 08:29 AM
#18
Registered
Joined: Feb 2007
Posts: 946
Likes: 1
From: Franconia, PA
It should not be called "Production Class" or "P-Class"...that is not descriptive of the boats that are racing in Classes 1-6 in any of the organizations.I also think SBI should drop the P designations...too confusing considering a substantial part of thier fleet is made up of boats these classes.
Use of World or Worlds should be dropped totally as it is
not a world event. Should be North American Championships.
Gino's cup could be called American Challenge Cup.
Class 5 year end hi points trophy should be Reiter Cup.
Rich
10-28-2008 | 09:15 AM
#19
Thread Starter
Registered
Joined: Apr 2003
Posts: 2,824
Likes: 0
From: Va Beach, VA
Frank...I like the World Challenge Cup....
Every Org has a shoot at the Cup...even if they are from across the pond.....
Rich....I also like the idea of the Class 5 Championship call the Riter Cup.....
For next year....We can find a series sponsor for the Cup....and we can spit up the money to all P Class teams that make K.W.
The Cup will be done on Thurs morning...I will post a picture of it on here....
Every Org has a shoot at the Cup...even if they are from across the pond.....
Rich....I also like the idea of the Class 5 Championship call the Riter Cup.....
For next year....We can find a series sponsor for the Cup....and we can spit up the money to all P Class teams that make K.W.
The Cup will be done on Thurs morning...I will post a picture of it on here....
Last edited by MANITIE; 10-28-2008 at 09:25 AM.
10-28-2008 | 10:58 AM
#20
Thread Starter
Registered
Joined: Apr 2003
Posts: 2,824
Likes: 0
From: Va Beach, VA
Here is a picture of the Cup.....
It will be on a differant base that is 7 inches high and then the Cup stands another 14 inches high and the diamiter of the Cup is 11 inches....
The face plate will be on the front and have the Cups name on it and then we can start ingraving it starting this year...as the years go on and the face place fills up we then can add more plates on each of the 4 sides....
I want to thank Al at CrownTrophys for putting this trophy together....
It will be on a differant base that is 7 inches high and then the Cup stands another 14 inches high and the diamiter of the Cup is 11 inches....
The face plate will be on the front and have the Cups name on it and then we can start ingraving it starting this year...as the years go on and the face place fills up we then can add more plates on each of the 4 sides....
I want to thank Al at CrownTrophys for putting this trophy together....
Last edited by MANITIE; 10-29-2008 at 10:26 AM.
