Pantera at SCOPE Poker Run
10-08-2007, 01:14 PM
#52
Platinum Member
Platinum Member
10-09-2007, 01:02 AM
#54
Registered
Thread Starter
Join Date: Nov 2006
Location: Huntington Beach, CA
Posts: 1,955
Likes: 0
Received 0 Likes
on
0 Posts
I was actually standing next to Casper when I took that photo of the oil pan. That thing is a beast! I could look at the bottom end of that motor all day... (Don't tell my wife 
)
Here's a couple of photos of the new motor (aka "Casper") before it left Miami and back in the good old days. I may not have the Mig, but I have a little bit of it's spirit our here in CA!
)Here's a couple of photos of the new motor (aka "Casper") before it left Miami and back in the good old days. I may not have the Mig, but I have a little bit of it's spirit our here in CA!
10-10-2007, 12:35 PM
#56
Back out of the Game!
Gold Member
Join Date: Sep 2006
Location: Lake Huron, Thumb of Michigan
Posts: 436
Likes: 0
Received 0 Likes
on
0 Posts
Everything looks awesome Dude!
Are those the CMI Unitops that you modified? what is the power gain on them vs the sectioned manifolds like the Dana's ??
I am really struggling with exhaust choice performance vs low cost, thanks!
Are those the CMI Unitops that you modified? what is the power gain on them vs the sectioned manifolds like the Dana's ??
I am really struggling with exhaust choice performance vs low cost, thanks!
10-10-2007, 12:51 PM
#57
Registered
Thread Starter
Join Date: Nov 2006
Location: Huntington Beach, CA
Posts: 1,955
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Mike! It will look even better under a bad-ass scooped race hatch!
Those are CMI's. That's what was on the boat. I've been told, by people I trust, that the SMI Gen III make significantly more power than the CMI unitops. People do love to argue about it though!
But, I had the CMI's and it was a grand to modify them, vs. buying SMI's and doing the tails, so this is the route I went for now.
Those are CMI's. That's what was on the boat. I've been told, by people I trust, that the SMI Gen III make significantly more power than the CMI unitops. People do love to argue about it though!
But, I had the CMI's and it was a grand to modify them, vs. buying SMI's and doing the tails, so this is the route I went for now.
10-10-2007, 12:54 PM
#58
JC Performance Engines
Gold Member
mike, i think w/ the power you're putting in, you could use the SM GenII. Something nice about a 5yr warranty.
They don't look to bad eiter.
They don't look to bad eiter.
10-10-2007, 12:57 PM
#59
Back out of the Game!
Gold Member
Join Date: Sep 2006
Location: Lake Huron, Thumb of Michigan
Posts: 436
Likes: 0
Received 0 Likes
on
0 Posts
