The interior was supposed to be shipped yesterday or perhaps today.:D[/QUOTE]


It is on it's way across the pond:D

The interior is STILL at the port in Ft Lauderdale waiting to be loaded in the container. :(

Anyone know of any shipping agent in Ft. Lauderdale that can ship this in the close future?!

In the meantime I have been building the base for the rear seats and a lot of other minor things.

Since the inner transom plate was cracked I have a new IMCO plate on it's way from Mr Gadgets.

Tomas, was the transom plate causing you any problems w/ the coupler?

It's possible! But I can't tell for sure since the transom plate might have cracked when the coupler broke. But the alignment was off before and that might have been the transom plate that was bad.

The coupler broke kind of dramatically...:evilb::rolleyes:

I used World Wide ship in Ft Lauderdale (mid 2005) to ship a Pantera to the UK - England - contact at that time was Charlotte Thomas - [email protected].

Eventually sorted me out on a RoRo outa Charleston.

The interior is finally on its way over the Atlantic! Should arrive aug 18th!

The base for the back seat is ready for mounting, just the final adjustment of the height when I get the back seat then the base will be glassed into place!

It will have two hatches and an air vent in the front and integrated boxes for the speakers. The inside will get a second layer of black gelcoat when it's glassed in place and I will put black mat on the outside (the same kind of mat that the sides of the cockpit is covered with now).

The base for the front seats will be ordered when I have decided on the height, the guy that will make it needs about a week to finish it!

FINALLY!!!:evilb:

The interior arrived last night, will start the mockup later today!

Now we're getting there, test mounted the interior last night and got the final dimensions for the bases.

It fits perfectly!!!:evilb: I thought you guys at PPI would make it more on the safe side but this is amazing!

I will adjust the drawings for the front base today and send it to the guy that will be making it for me. He will probably be done within a week or so!

The rear base will be adjusted today and glassed in place. When that's done I will start mounting the steering wheel and all the switch panels.

Here's a couple with my friend showing some proportions of the interior.

And one of the mockup plate for the foot rests and foot throttle base. The foot rests need to be this high since the floor is lowered about 4 inches.

That's some SERIOUS seating Tomas! the side support in the back seat is awesome ......:party-smiley-004: