Well here goes. It's a 1996 28' that has never seen water . It has a 3 man boster with center steering set up and 2 fuel tanks.
I have custom k-tabs and a pair of latham hyd. steering rams to go with it . The hole has been cut for a bravo but the exhaust has not been cut. The dash has been cut but no guages.

I also have a motor I purchased that is still on the skid and never been fired. It's a bb 585hp 9.5:1 steel rods; hyd crane roller cam #139651:dart alum heads with crower rollers;dart alum intake w/1050 dominator and a pair of stelling swept backs. I have dyno sheets as well as flow bench test and cam card.

p.s. : I also have a used 7.4 lt 330hp long block


I am asking $22000.00 us for b/m and $1400.00 for long block.

This was the hardest ad i have ever done.

ummmm.....$1400 for the 585hp??

Bummer. Sounds like you have her almost built the way you wanted it.

There ya go Fred..another project!

Bordeline,

Please check your (private mail).

Sorry to hear the news.

Pantera24
Angel

Anyone know what this boat looked like?