I thought I recognized that boat!

Thanks!
This is a better one from a couple of years ago. Sounding good.

The LKN Fun Runs are always a blast.

Forgot to post my setup is an inch lower than yours at 7.5"
That is awesome thanks for sharing

forabeer,
when was the boat converted to bravo ?
who decided to mount the transom assembly "(X)" where it is ? and why ?

asking because it was a tough decision for me, same measurement on my boat is 8 3/4.
have to check the notes but from memory X was 17 5/16, that should make the
propshaft height 4 1/2 inches below the bottom.

I bought the boat n 2010. It spent most of its life on Lake George NY. (pic attached from its Lake George days. Old Logo, tall scoop)
I did not set the x dimension. Boat was originally a TRS with big block. Previous owners had 800+ hp blower motor with the hopes of hitting the magic century mark. (hence x dimension, huge tabs, full hyd steering, etc) They ran the boat to low 90's. I am pretty sure my prop shaft is around 5" below bottom.https://cimg4.ibsrv.net/gimg/www.off...214d53d0d2.jpg