Found my boat
#13
Registered
Thread Starter
Well, nothing to post yet. It was Disney this weekend and last weekend getting my Sea Ray Sundancer ready to sell. The Sea Ray is on the lift I want to put the Pantera on. This next weekend I will get it in but may not hit 10 hours- break in. I'll have to take it easy.
It is spotless though and ready to go!
It is spotless though and ready to go!
#17
Registered
Thread Starter
Hey guys,
No good news to report here yet. Put on a 28 Four blade and 4000 rpms with a full tank . Running very rich also.
Boat is awsome to drive though. I love it.
Unbelieveable how well it cuts through rough water compared to my last Donzi
28ZX with twins.
Problem is the boat has not been fine tuned.(hopefully) I wasted alot of time thinking it would be fine while I waited on my prop and did some other things.
There are not many people around here that I am comfortable with to work on it.
They should be on it next week. I have been looking at some other engine options if this engine does not put out 550 to 575hp.
Von, how much rpm & speed difference did labbing your 28 make?
I'll keep you posted,
Greg
No good news to report here yet. Put on a 28 Four blade and 4000 rpms with a full tank . Running very rich also.
Boat is awsome to drive though. I love it.
Unbelieveable how well it cuts through rough water compared to my last Donzi
28ZX with twins.
Problem is the boat has not been fine tuned.(hopefully) I wasted alot of time thinking it would be fine while I waited on my prop and did some other things.
There are not many people around here that I am comfortable with to work on it.
They should be on it next week. I have been looking at some other engine options if this engine does not put out 550 to 575hp.
Von, how much rpm & speed difference did labbing your 28 make?
I'll keep you posted,
Greg
#19
Registered
Thread Starter
Ironman, Holley 850 with primarys 2 jet sizes over and 4 jet sizes over on secondaries according to the builder. It does not have a notched transom. Fair amount of soot on the transom after running several hours.
Greg
Greg
#20
Charter Member
Charter Member
I am not sure what the carb comes with initially but I have had good luck with 80's in the primary and 85's in the secondary with a power valve or 92's without. That is in a 509" hyd roller engine. Did you sea trial before you bought it, how did it run then?
Oh did I say that is a great looking boat.
Oh did I say that is a great looking boat.