![]() |
Originally Posted by docmanrich37
(Post 2189095)
Excursion starting the fast boats.:evilb:
I didn't say you couldn't pass him!:D |
Steve shouldn't you have a fast boats start the fast boats. James will be so far behind by the time they get to the power lines, the slower boats will have caught up with him.
Terry |
Originally Posted by runnin gun
(Post 2189226)
Steve shouldn't you have a fast boats start the fast boats. James will be so far behind by the time they get to the power lines, the slower boats will have caught up with him.
Terry |
Not me!#! I just pull the Aces.....Last one to get cards usually wins!
Seriously, is anybody gonna run low 70's? |
low 70's!!! I'm cruisin at 50 -55.......It's not a ace...just save me a good slip:p
|
A word of towing advice. AVOID TOWING ON I-295 in the Richmond area. It is concrete, and is VERY bumpy. MANY boats/trailers have jumped off the hitch ball and other damage over the years. I just drove I-295 North of Jordan Point/Hopewell, and the rear of my truck was getting air (not towing).
Use I-95 instead. It may take you 5-10 minutes longer, but its absolutely worth it. I saw the slip assignments tonight at Jordan Point. They are not too bad. |
Originally Posted by Sydwayz
(Post 2189448)
A word of towing advice. AVOID TOWING ON I-295 in the Richmond area. It is concrete, and is VERY bumpy. MANY boats/trailers have jumped off the hitch ball and other damage over the years. I just drove I-295 North of Jordan Point/Hopewell, and the rear of my truck was getting air (not towing).
Use I-95 instead. It may take you 5-10 minutes longer, but its absolutely worth it. I saw the slip assignments tonight at Jordan Point. They are not too bad. |
Thanks Brian. My trailer is not the best and I try to baby it even though I look it over good before we tow.:rolleyes:
|
Originally Posted by slboatdrinks
(Post 2189450)
Do you mean Tide Water?
|
Brian I tow down I-295 from I-64 to route 10 everyweekend and have not yet had a problem. You just have to know were the big bumps are. If you have the right ball size ball for your cupler it should not jump off anyway.
Just my .02cents. Terry |
| All times are GMT -5. The time now is 06:03 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.