Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: SRQ
Showing results 1 to 1 of 1
Search took 0.00 seconds.
Forum: Drives and Lower Units
05-20-2014, 12:36 AM
Replies: 52
Views: 18,672
Posted By SRQ

No need to cut down a perfectly good Bravo XR...

No need to cut down a perfectly good Bravo XR propshaft just to fit a BI gear.
Just bore the gear on a lathe with the appropriate insert. This gear measured a hardness of 61.5 RHC and I had it...
Showing results 1 to 1 of 1


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.