PowerQuest260HO

Having owned my 260sx legend for a couple of years now looking to squeeze some more speed out of here. It has the 496HO, She currently GPS @ 58 at 4600rpm. I'm looking at pulling the corsa exhaust W/mufflers non Switchable to running straight through W/flaps. Then looking at sending the prop in to get labbed. I do have tabs so hopefully they can squeeze a bit out of the prop. Was even thinking of new manifolds not sure how much more that would give me.

Baja_man

Prop is the cheapest and easiest way to gain a few MPH...everything thing else gets expensive.

THE 288 KID

What size you running currently. I still have a buddies labbed 26p that its basically brand new sitting around I haven't got back to him yet.

Pulling the "turbolator" plates out of the exhausts has shown 10-15hp on the dyno. I'm sure someone will dispute this but I read it online so its gotta be true! They even had a dyno sheet with colored lines to prove it! Lol

Knot 4 Me

What prop and what pitch are you running? You should be turning 5K RPM at WOT so you are leaving speed on the table.

PROWRENCH

I would agree you are definitely leaving some speed on the table. You should run 65mph with that HO at least. Leave the nice personality girls at the dock!

Bob280Silencer

LOL...."nice personallity girls at the dock "Depending on how nice they are,that might get that last 400 rpms out of that HO

bert4332

If you're running a 23p Mirage Plus, be aware it's not a "true" 23. I'd go with a 22 or 21 Hydromotive QIV. I made the mistake of going with a 23 Hydormotive QIV, although up 2mph it bogged down my rmps. It did cure my chine walk in an instant, but I wish I went with a small size.

pqjack

agreed...was running 62-63 @4900 in my 27 lazer with 454/385

Drock78

iTrader: (2)

Pull the 496 out and put a real motor in it. They are a heavy boat for 26'

Josh LaFountain

525sc